RCD 300: External Operation & Setup

Hi!

I want to operate my RCD 300 externally, meaning not inside the car.

So far, so good. The radio turns on and works fine, but after 1 hour, it turns off. When I turn it on again, it works properly for another hour.

I have also already attached a GW 7N0 907 530C, but I am experiencing the same problem .

I have attached the relevant document.

Does anyone have a tip for me?




Connector, 20-way, T20.

1 - 30
2 -

10 - Can-Bus Infotainment, Low.
11 - Mass
12 -
13 -
14 - 30
20 - CAN-Bus Infotainment System, High-End.

I suspect that terminal 15 is missing from the CAN bus.
Does the gateway have a corresponding contact?

Maybe a little late, but I'll give it a try.

ID 661, 0300000000000000.

It at least brought the PFSE to life.