CANhack.de CAN-Interface RKS+CAN
CAN Hardware, CAN Software, CAN Protocols - CAN Bus Forum for Your CAN Bus Project.

Wiring Questions: Get Answers Now!

 
New Topic Reply 🔗 🖨 CANhack.de - Index » Vehicle-specific Hardware and Pin Assignments
Author Message
rathma
Guest




 


Free account, no CAN development support

Post10-10-2006, 0:35    Subject: Wiring Questions: Get Answers Now! Quote

Hi,
Okay, here's a fundamental question about wiring:
The CAN bus has a bus-like structure, not a star-like one, right? This means that for example, in the engine CAN, the two twisted pairs of wires run from the ABS control unit to the engine control unit and then to the instrument cluster. Does this mean that one of the three control units must have four CAN cables connected to it?
I have a Golf IV MJ98, so one without CAN bus. The KI (instrument cluster) definitely doesn't have it (I checked). However, according to the wiring diagrams, it should be present on the engine control unit (at least it's shown in the schematics).

Is the motor fan actually connected to the climate control unit?

Best regards.
Markus.


Translated on 03-08-2026, 0:02.
Back to top
New Topic Reply 🔗 🖨 CANhack.de - Index » Vehicle-specific Hardware and Pin Assignments
Jump to:  
You cannot post new topics in this forum.