AGV 4000 V6.1: CanHacker Integration & Setup

Hello,

I am currently using the AGV 4000 expert adapter in Lawicel mode with the can tool.
I performed the following tests on my Ford S-Max, which was manufactured in July 2012.

The connection to the interface was established without any problems.
After opening the interface, no data was initially received from the CAN bus, which was also confirmed by the LED on the interface.

Data was only received after a message was sent.
The connection then dropped after approximately 10 seconds, but the RX/TX LED on the adapter continued to blink.
I could only receive messages again after sending another message.

In addition, the data bytes were only visible in the dialog when the telegrams were 8 bytes long.
Did I miss any settings?