VW Polo 9N3 DIAG connector

Hi, I've had a new Polo 9N3 for about 2 months now, and I'd like to know...
where the diagnostic interface is located. Taking out the speedometer or the radio to access the CAN bus doesn't seem very practical to me.

The 9N3 only has a single CAN interface. I also don't want to disconnect it from the MOST system. VW/Audi probably has some kind of interface located inside the car. Unfortunately, the 9N3 is completely different from the 9N(2) in that regard. But still, thanks for the information. Let's go be friendly and ask where that thing is located.

Sure, here's the translation:

'MFG DaTaJaM' translates to 'Manufacturing Data Management' in English.

16-pin purple connector, located on the lower left side of the driver's footwell .

However, the diagnostic CAN system won't provide any information if you don't send it the correct messages.
Therefore, I would rather tap into the gateway control unit, as all the buses converge there.