CANhack.de CAN-Interface RKS+CAN
CAN Hardware, CAN Software, CAN Protocols - CAN Bus Forum for Your CAN Bus Project.

Renault Megane IV RPM signal

SearchSearch  BookmarksBookmarks  GarageGarage  InfoFAQ, Legal Notice & Privacy
RSS FeedRSS Feed  RegisterRegister  LoginLogin DE | EN | IT
 
New Topic Reply 🔗 ⭐ 🖨 CANhack.de - Index » General View previous topic :: View next topic
Author Message
kenn



Joined: 10/07/2017
Posts: 1
Karma: +0 / -0   Thank you, like it!


Free account, no CAN development support
Post07-10-2017, 22:52    Subject: Renault Megane IV RPM signal Quote
Hello,

I would like to obtain the RPM signal from the Renault Megane IV via the CAN bus.

Does anyone have information about the message so that I can eventually figure out the correct speed?

Thank you in advance.


Translated on 03-07-2026, 15:19.
Back to top Profile PM
Paulius
Hacker
Hacker


Joined: 11/13/2013
Posts: 61
Karma: +7 / -0   Thank you, like it!


CAN Support
Post11-10-2017, 9:21    Subject: Renault Megane IV RPM signal Quote
Connect to the OBD connector using pins 6 and 14. Finding the RPM is very easy.
Just check changes on the CAN bus when the engine is running and accelerate it a little bit. icon_wink.gif


Translated on 03-07-2026, 15:19.
Back to top Profile PM
New Topic Reply 🔗 ⭐ 🖨 CANhack.de - Index » General View previous topic :: View next topic
Similar articles and topics
Topic Forum
No new posts CAN Bus Renault Megane 3 Interior / Comfort CAN
No new posts Convert Audi CAN to VW CAN Signal General
No new posts Disable Tire Pressure Monitoring System (TPMS) Megane II ... Diagnostic CAN
No new posts Audi A5 - CAN ID Speed / rpm Interior / Comfort CAN
Jump to:  
You cannot post new topics in this forum.
Foren- und Portal-Software: V7.8 © 2003 - 2026 Kaufmann Automotive GmbH, Embedded Software Freelancer & Car Diagnostic Tools Shop. Parse time: 0.042s

Bloggerei.de TopBlogs.de das Original - Blogverzeichnis | Blog Top Liste
CANHack.de on ForumRankings.net