ECU Keypad Programming: How-To Guide

Hello.
Last winter, I started my small beach buggy project. For that, I bought an AIM PDM 32. In addition to that, I also got an ECU Master 12-key pad.

The AIM PDM32 comes with RaceStudio 3 software, which allows you to reprogram the CAN bus parameters.

I've never had anything to do with it before, I did some reading, I was a bit nervous, and I completely messed it up.

I should have entered "0X19" during the programming process to change the ID to 19 (it was previously set to 0x15).

Unfortunately, I only entered "19".
After the restart, the keypad was no longer responding.

Now, could someone please help me figure out how to find and change the ID to 0x19 so that the PDM can recognize the buttons again?

I live in Marburg, and I would also be happy to just hang out . But I am open to all suggestions.

Thank you and best regards.

The Hightower.

Hallo,

Dein "ECU Keypad" ist mir völlig unbekannt, hat auch nicht wirklich mit CAN zu tun. Verschiebe es daher in einen passenderen Bereich.

19 dezimal (wenn es Dein Gerät so interpretiert hat) entspricht 0x13 (hexadezimal).

https://www.matheretter.de/wiki/hexadezimalzahlen

Viele Grüsse, Rainer

Hi and thank you .

Unfortunately, it didn't work with 0x13.

Is there anyone here who has a sniffer and can somehow extract the ID?
I'm at my wit's end.

Habe hier so viele CAN-Bus Sniffer, dass ich die sogar verkaufe. Ein Heimatbesuch bei Dir dürfte aber über den kostenlosen Supportrahmen hinausgehen.