CANhack.de CAN-Interface RKS+CAN
CAN Hardware, CAN Software, CAN Protocols - CAN Bus Forum for Your CAN Bus Project.

CAN IDs for new Sprinter

 
New Topic Reply 🔗 🖨 CANhack.de - Index » Interior / Comfort CAN
Author Message
timo81
Guest




 


Free account, no CAN development support

Post11-05-2007, 11:36    Subject: CAN IDs for new Sprinter Quote

hello everyone,
This is a really great forum! I'm looking for part numbers for the interior of the current Sprinter (NCV3). I'm particularly interested in the clutch, handbrake, and ignition key.
Maybe one of you has something suitable.
'Thank you very much!'
Best regards.
timo


Translated on 03-07-2026, 15:19.
Back to top
rathma
Guest




 


Free account, no CAN development support

Post11-05-2007, 13:59    Subject: CAN IDs for new Sprinter Quote

Okay, I'm not really an expert on buses, but if the handbrake and clutch are located inside the passenger compartment (which I find highly unlikely for logical reasons), then you would have figured it out within a minute. Just pull the handbrake and see what changes.


Translated on 03-07-2026, 15:19.
Back to top
New Topic Reply 🔗 🖨 CANhack.de - Index » Interior / Comfort CAN
Similar articles and topics
Topic Forum
No new posts Mercedes Sprinter > 2013 General
No new posts Retrofitting Xenon headlights to a Sprinter W906 Vehicle-specific Hardware and Pin Assignments
No new posts CAN Bus Diagnostics: Mercedes Sprinter Troubleshooting Vehicle-specific Hardware and Pin Assignments
No new posts Mercedes Sprinter W906 - CAN Bus Interior Bitrate Vehicle-specific Hardware and Pin Assignments
Jump to:  
You cannot post new topics in this forum.